How can I clean our mono- block driveway
Engine oil has been dropped on the driveway and l do not know what to use
to clean it, that wo not damage the paving or discolour it. It is a
mixture of blonde and red mono block bricks Thanks for
replies
jet wash wont do you need to go to B&Q or wickes to get drive
way cleaner or try laundry powder it contains enzymes that eat away oil
and grease, you can pressure wash after
4 pints boiling water 1 cup vinegar 1 cup sugar mix well pour
onto oil and leave for few mintes(like 3-4)) then lighty scub off with
hose and soft brush..Good as new. :)
Try not to use strong liquids.
Have a gander at the B&Q patio cleaner range.
Cheapest way is rubbing in some laundry detergent with a yard brush- Daz
etc. and then washing it off 10 mins later with warm water!
pressure wash it if that dont take it up brush some goop on the
area then pressure wash again
5 posts
• Page 1 of 1
Have you ever considered asphalt? Have you ever walked barefoot across a road during a hot summer day? Have you ever tried picking up a metal?? How much oil does it take to pave a mile of a 2 lane highway? why osent my newly paved driveway harden up after 7 days Find the area of each rectangular lot. CB problem What amount, if any, should an almost victim pay someone who saved him from foolishly paying for a scam?? Viscosity question why not plant trees to fight global warming tank damage on paved roads Can you see what you're missing If I run for President.... why are some roads done in concrete and others in blacktop Who is onlineUsers browsing this forum: 4 guests |